Your question: What two lines connect transmission to the radiator?

What transmission line goes to the radiator?

How Car Transmission Lines Work. Car transmission lines connect your vehicle’s transmission to the vehicle’s radiator. Also known as transmission cooling lines, they are typically made of metal or composite aluminium and rubber hoses because they can handle the flow of hot transmission fluid.

How do transmission cooler lines connect to radiator?

Transmission coolers do not attach to the radiator. They attach in-line with the transmission fluid return line. It is common for an OEM transmission cooler to be built into the radiator tank to be cooled by the coolant in the radiator.

Does the radiator connected to the transmission?

The largest component to your vehicle’s cooling system is the radiator, but did you know that the radiator is also connected to your transmission and in some cases your engine’s oiling system too? Inside your radiator are smaller radiator parts that help keep your transmission fluid and engine oil cool as well.

What is a transmission line connector?

Line connectors are most commonly made of steel. They are attached to your vehicle’s transmission lines with a compression fitting made to withstand temperature, pressure, and automatic transmission fluid (ATF). The fitting between the line and the connector often requires special tools and machinery to create.

THIS IS INTERESTING:  Your question: How can I get a discount at NAPA Auto Parts?

What does the transmission cooler line do?

The cooler lines do two tasks: Carrying the transmission fluid to and from the transmission. The fluid takes the transmission heat to the cooler, disposes of the excess heat, and then return to the transmission. Transporting the fluid back and forth to an external or radiator-integrated cooler.

Can I use rubber hose for transmission cooler lines?

You can use rubber hose, but make sure it’s transmission cooler line rated. The pressure is quite low (12-15 psi). Double clamp it or use FI type clamps instead of the worm-drive style.

Are transmission coolers directional?

The driver side of the radiator based cooler is connected to the front port on the tranny. The rear port on the tranny goes into the secondary cooler which then feeds into the driver side of the radiator based cooler. So, something is backwards.

How do you install a transmission line?

How to Change Transmission Lines: Do It Like a Pro

  1. Raise the Vehicle.
  2. Drain the Transmission Fluid.
  3. Remove the Transmission Cooler Lines.
  4. Drain More Fluid.
  5. Spray Brake Cleaner.
  6. Install the New Transmission Lines.
  7. Replace the Transmission Fluid.
  8. Lower and Start your Vehicle.

Can I run two transmission coolers together?

In series is fine. One in front of the other will be a not be much more effective than just one. One reason is the air that goes thru the front cooler gets heated up and is less effective as it goes thru the rear.

Where are transmission cooler lines?

Remove the two transmission cooler lines from the bottom of the radiator. These two lines can be accessed either from underneath the hood or underneath the vehicle. Use the flare nut wrench to remove the lines in the same manner used to remove the lines from the transmission.

THIS IS INTERESTING:  What material are car doors made of?

What is connected to a radiator?

The upper radiator hose is connected to the thermostat housing and to the radiator. From the bottom of the radiator, is the lower radiator hose that is directed to the water pump. Powered by the vehicle’s water pump, the engine coolant loses its heat after passing through the radiator.

What is RF transmission line?

The transmitter that generates the RF power to drive the antenna is usually located at some distance from the antenna terminals. The connecting link between the two is the RF transmission line. Its purpose is to carry RF power from one place to another, and to do this as efficiently as possible.